zti error opening sql connection: cannot initialize sspi package

zti error opening sql connection: cannot initialize sspi package (Full Version)

All Forums >> [Management Products] >> System Center Products >> System Center Configuration Manager

Message

lnesta431 -> zti error opening sql connection: cannot initialize sspi package (5/19/2008 10:02:08 AM)
I receive this error in ztigather.log during "Configure" action (MDT with SCCM) When I troubleshoot the connection via the following way, I don't have any issue and the I gather the correct info out of the DB. Copy ztighater.xml, ztigater.wsf, ztiutility.wsf and CS.ini to one folder and run cscript.exe ztigather.wsf /debug:true I found a KB telling that I have to rename security.dll but I cannot find that file. The server 64-bit the boot image i 32-bit. Anyone an idea? Thanks Nico

lnesta431 -> RE: zti error opening sql connection: cannot initialize sspi package (5/19/2008 10:33:38 AM)
more info It works when I do the test in Windows Doing the same test in WinPE, I have the same error. So must be something with my boot image. Though ADO support is enabled...

cwysong -> RE: zti error opening sql connection: cannot initialize sspi package (6/16/2008 1:43:16 PM)
I just ran into this issue last week, and I have the exact problems that you state. I run ZTIGather /debug:true in one folder to test, and it works fine. When I try to run this in WinPE I get the ZTI error opening SQL Connection: Cannot initialize SSPI error. Have you had any luck in troubleshooting this issue? Thanks, Chris

lnesta431 -> RE: zti error opening sql connection: cannot initialize sspi package (6/17/2008 2:40:18 AM)
Hi Yes after stuggeling a while [&:], the root cause was that I copied my customsettings.ini of an earlier an env. In the CS.ini was a variable specified that was not existing in the database. (I did not use that value anymore, it was %keyboardlocale%) So apperenlty the Configure Action was hanging because the value could not be located in the database. Stupid but I lost a lof time with it!! Why can't WinPE just pop-up an error?? So What I would advice is to check your CS.ini, word by word to see if there is no problem here... Anyway hope you have some luck... Nico

lnesta431 -> RE: zti error opening sql connection: cannot initialize sspi package (6/17/2008 8:11:13 AM)
Apparenlty I blogged something about it ;-) http://nicosienaert.blogspot.com/2008_05_01_archive.html#9218511082567336305

Page: [1]

Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI

0.28125