|
bwilms -> RE: What should I see after R2 is installed? (9/18/2008 4:50:26 PM)
|
Okay, I dug around a bit more, and this is what I have found so far.
There are an additional 15 reports:
All distribution points with virtual application streaming enabled
All system resources in a specific state for a specific task sequence advertisement available to unknown computers
All task sequence advertisements available to unknown computers
All virtual application packages in the streaming store of a distribution point
Computers with a specific virtual application
Computers with a specific virtual application package
Count of all instances of virtual application packages
Count of all instances of virtual applications
Status for a specific computer of a task sequence advertisement available to unknown computers
Status of all unknown computers
Status summary of a specific task sequence advertisement available to unknown computers
Streaming store distribution status of a specific virtual application package
Virtual application launch failures for a specific application
Virtual application launch failures for a specific computer
Virtual application launch failures over a number of days
When you go to Software > Distribution > Packages > Right-click > New, you now have a "Virtual Application Package" option.
Client Status Reporting is not installed by default. It must be installed manually after R2 has been installed. You can install Client Status Reporting from [CDDRIVE]:\CLIENT STATUS REPORTING\CLIENTSTATUSREPORTING.MSI. The documentation provides a lot of info about setting it up, including the Importing of SCCM Reports.
|
|
|
|
