Help with Cisco Devices (Full Version)

All Forums >> [Management Products] >> System Center Products >> System Center Operations Manager



Message

K3HTK -> Help with Cisco Devices (10/8/2008 10:27:51 AM)

I am trying to setup a Cisco 4510 in SCOM and cannot seem to figure out how to get my interfaces listed on the device. I would like to monitor thresholds on the interfaces for packets sent and received but am having a hard time getting this done. After discovering my switch, all I see is the name and Healthy status that it is up but I need to monitor down to the port levels on the blades.

Any help or guided reading / examples would be great.... Thank You!

Ed



eyona -> RE: Help with Cisco Devices (10/15/2008 11:49:28 AM)

well discovering interfaces is a bit tricky, I wrote the detailed explanation as blog post at Monitoring Network Switches and Interfaces
the article refers to Cisco 3560 but I believe you can adapt the example mp to your needs



K3HTK -> RE: Help with Cisco Devices (10/15/2008 2:41:24 PM)

Great! Thanks for sharing the info.... I will check out your post.... You have a link to it?

Thank you,

Ed



eyona -> RE: Help with Cisco Devices (10/15/2008 6:15:56 PM)

i included the link in the first post here it is again: http://myitforum.com/cs2/blogs/idany/archive/2008/10/15/monitoring-network-switches-and-interfaces.aspx



K3HTK -> RE: Help with Cisco Devices (10/16/2008 4:40:53 PM)

Sorry.... I should have paid a little closer attention... Thanks again!

Ed



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4.5 ANSI
0.390625